Calls answered around the clock ยท connections 7 AMโ€“7 PM Call (707) 418-4772How it works

Furnace blowing cold air

The blower runs but the air from the vents is cool. Here's how to narrow it down.

Referral line: your call is routed to a participating local heating & cooling company. How it works

Hand checking a floor vent blowing cold air from a furnace
Short answer: If your furnace blows cold air, first set the thermostat fan to Auto and replace a dirty filter. If the air stays cold, the burners probably aren't lighting or staying lit, usually because of a dirty flame sensor, failed igniter, pressure switch or an overheating shutdown. Call (707) 418-4772 to reach a local heating company.

1. Fan set to On

With the fan on On, the blower runs between heat cycles and pushes room-temperature air. Set it to Auto and see if warm air returns during heating.

2. Furnace just started

The blower may start a little before the heat exchanger is fully warm. A minute of cool air at the start of a cycle is normal.

3. Dirty flame sensor

Burners light for a few seconds, then shut off, and the furnace retries. This is very common in Solano County, where furnaces sit unused through a long, hot summer and dust settles on the sensor.

Homeowner installing a new air filter in a closet furnace
Homeowner installing a new air filter in a closet furnace

4. Failed igniter

You hear the small inducer fan start but never see the orange glow or the flame. After a few tries the furnace locks out and the blower may keep running.

5. Overheating from a clogged filter

The limit switch shuts off the burners to protect the heat exchanger, but the blower keeps running to cool it, which feels like cold air. Replace the filter and open all vents.

6. Heat pump, not a furnace

If your outdoor unit runs in winter, you have a heat pump. Brief cool air during defrost is normal. See heat pump not heating.

Stop and call if

you smell gas or burning plastic, see scorch marks or sparks, a carbon monoxide alarm sounds, or a breaker trips a second time. For gas or CO: leave the house and call 9-1-1, then PG&E at 1-800-743-5000.

Questions

Common questions

Can I clean a flame sensor myself?

It's a common DIY video, but it involves opening the burner compartment of a gas appliance. If you're not comfortable, call a technician.

Why does my furnace blow cold air only at the end of a cycle?

The blower keeps running briefly after the burners stop to pull remaining heat from the heat exchanger. That's normal.

Need heating or AC help in Solano County?

Tell the dispatcher what the system is doing and where you are. You'll be connected with a participating local heating & cooling company that serves your ZIP code.

๐Ÿ“ž Call (707) 418-4772

Referral line: your call is routed to a participating local heating & cooling company. How it works

๐Ÿ“ž Call (707) 418-4772 ยท heating & AC help