Calls answered around the clock · connections 7 AM–7 PM Call (707) 418-4772How it works

Furnace not turning on

No blower, no clicking, nothing. Start with power and controls.

Referral line: your call is routed to a participating local heating & cooling company. How it works

Furnace service switch and diagnostic light in a hall closet
Short answer: When a furnace does nothing at all, the problem is usually power or control: thermostat batteries or settings, the furnace service switch, a tripped breaker, a loose door that opens the safety switch, or a full condensate pan. Check those in order. If the furnace still won't respond, call (707) 418-4772.

The five-minute check

  1. Thermostat: on Heat, set 3°F above room temperature, screen not blank (replace batteries).
  2. Service switch: a light-switch near the furnace or on the closet wall. Someone may have flipped it off thinking it was a light.
  3. Breaker: labeled furnace, FAU or air handler. Reset once.
  4. Door: the lower panel presses a safety switch. If it's loose, the furnace won't run.
  5. Condensate: on attic and closet units with AC coils, a full pan or tripped float switch can cut power to the whole system.

Look for a blinking light

Most modern furnaces have a small LED visible through a window in the lower door. A blinking pattern is a diagnostic code; the legend is usually on a label inside the door. Note the pattern and tell the technician.

After a power outage

PG&E outages and shutoffs can leave a furnace dead even after power returns: a tripped breaker, a thermostat that lost settings, or a control board fuse blown by a surge. Check the breaker and thermostat first.

Stop and call if

you smell gas or burning plastic, see scorch marks or sparks, a carbon monoxide alarm sounds, or a breaker trips a second time. For gas or CO: leave the house and call 9-1-1, then PG&E at 1-800-743-5000.

Questions

Common questions

Why would a furnace suddenly stop working?

Most often a thermostat, power switch, breaker or filter problem. If those check out, a failed control board, transformer or safety switch is likely.

Should I keep flipping the breaker?

No. Reset once. A breaker that trips again is protecting against a fault.

Need heating or AC help in Solano County?

Tell the dispatcher what the system is doing and where you are. You'll be connected with a participating local heating & cooling company that serves your ZIP code.

📞 Call (707) 418-4772

Referral line: your call is routed to a participating local heating & cooling company. How it works

📞 Call (707) 418-4772 · heating & AC help