Calls answered around the clock · connections 7 AM–7 PM Call (707) 418-4772How it works

Furnace repair in Suisun City, CA

Fog off the Suisun Marsh makes winter mornings raw. When the furnace won't light, here's what to check first.

Referral line: your call is routed to a participating local heating & cooling company. How it works

A glowing hot-surface furnace igniter beside a thin metal flame sensor rod, with a gloved hand at the edge of the frame
Short answer: If your Suisun City furnace won't heat, check the thermostat, the furnace switch, the breaker and the filter. If it clicks without lighting, lights then shuts off, or blows cold air, the usual causes are the igniter, flame sensor or pressure switch. Call (707) 418-4772 to reach a local heating company covering 94585. If you smell gas, leave and call 9-1-1 and PG&E.

Winter beside the marsh

Suisun City borders the Suisun Marsh, the largest brackish marsh on the West Coast. The nearest NOAA normals station, in Fairfield, averages January lows of about 40.4°F, with around 8 nights a year at freezing or below. Tule fog settles over the marsh and the town on still winter mornings, and damp cold feels colder than the thermometer says. Furnaces and heat pumps in Suisun City do steady work from late fall into early spring.

How Suisun City homes are heated

The median Suisun City home was built in 1984. About 58% of homes heat with gas and 38% with electricity, the highest electric share of the three central Solano towns (Census ACS). That means a mix of gas furnaces, many in the attic or a hall closet, and heat pumps. Heat pump owners should see heat pump repair in Fairfield and Suisun City; this page is about gas furnaces.

Quick checks before calling

  1. Thermostat on Heat, set 3°F above room temperature, fresh batteries.
  2. Furnace service switch on (it looks like a light switch near the unit), breaker not tripped.
  3. Furnace door or panel fully closed. An open door keeps a safety switch from letting it run.
  4. New filter if the old one is grey.
  5. Fan set to Auto. On blows cool air between heating cycles.

If it still won't heat after one reset, stop there. Repeated resets can mask a real fault. The full checklist is in the furnace repair guide.

A portable electric space heater on a tile floor with clear space around it in a cozy living room at winter dusk
A portable electric space heater on a tile floor with clear space around it in a cozy living room at winter dusk

The usual first-cold-night failures

  1. Dirty flame sensor: the furnace lights, runs a few seconds, then shuts off and retries. See igniter vs flame sensor.
  2. Cracked or weak hot-surface igniter: you hear the inducer fan, but there's no glow and no flame.
  3. Pressure switch or blocked vent: the inducer runs and nothing else happens. Check that the exhaust pipe outside isn't blocked.
  4. Clogged filter: the furnace overheats and trips its limit switch, then cycles on and off.
  5. Fan set to On: cool air between cycles that feels like a broken furnace.

Gas and carbon monoxide safety

If you smell rotten eggs near the furnace or water heater, leave the house, don't touch switches, and call 9-1-1 and PG&E at 1-800-743-5000 from outside. A furnace that set off a carbon monoxide alarm should not be restarted until a technician has checked it. See burning or gas smell.

Neighborhoods covered

ZIP code 94585, including Old Town and Victorian Harbor, Peterson Ranch, Montebello Vista and Lawler Ranch. Replacements need a permit from the Suisun City Building Department. More local information is on the Suisun City page.

What to tell the dispatcher

  • Your ZIP code (94585).
  • System type: gas furnace, wall furnace, heat pump, boiler or central AC.
  • What it's doing, in one sentence.
  • What you already checked.
  • Whether anyone at home is vulnerable to heat or cold.

Ask the company for its C-20 license number, arrival time, how the diagnostic visit is charged, and a written price before work starts.

Questions

Suisun City furnace questions

Why does my furnace light and then shut off after a few seconds?

Most often a dirty flame sensor. The furnace can't confirm the flame, so it shuts the gas off for safety. A technician can clean or replace it.

Is a dusty smell normal the first time the heat comes on?

A light dusty smell for several minutes is normal. A lasting, electrical or rotten-egg smell isn't; shut it off and see the gas safety steps.

Does the line cover all of Suisun City?

Yes, ZIP code 94585.

My furnace is in the attic. Can I check it myself?

You can check the switch, the filter and the breaker. Leave burners, gas parts and electrical panels to a technician.

No heat in Suisun City?

Tell the dispatcher what the system is doing and where you are. You'll be connected with a participating local heating & cooling company that serves your ZIP code.

📞 Call (707) 418-4772

Referral line: your call is routed to a participating local heating & cooling company. How it works

📞 Call (707) 418-4772 · heating & AC help